Top quality, made by MRB. Lambretta TS1 / RB manifold to PHBH / VHSH carburettor
Also fits Mikuni TMX 35mm/Amal carburettor to PHBH manifold
MBD designed high quality Viton carb mounting rubber.
Simple way to swap carbs if you want to go smaller from say a 34/35mm Mikuni or Amal down to a 28/30mm Dellorto.
Or you can go up from a 28/30mm Dellorto to a 34/35mm Mikuni or Amal.
No need to remove and replace the inlet manifold.
Large end diameter of spigot is 40mm
Small end diameter of spigot is 35mm
The rubber measures 30mm in length.
Can come in Black or Brown depending on stock.
Make sure both inlet manifold and carb are clean and dry before fitting
Always use the wide type Jubilee clips
Do not over tighten the clips
Always carry a spare
If your using a Mikuni TMX carb then always fit the spacer ring MRB0854 or the carb rubber will split, you can buy this here: http://www.lambrettaupgrades.co.uk/apps/ webstore/products/show/7092253
Also suitable for Vespas running a PHBH carb with a manifold spigot O.D. of 40mm
Price inclides VAT @ 20%